| |
need to consult us
Please call hotline
+86-576-87556858 |
|
|
|
 |
News |
 |
| |
"Throttle body" cleaning method, cleaning yourself and save both time and money
|
| Release time：2014.04.23 News source：Yuhuan TRV Throttle Body Co.,ltd,Throttle Body,Throttle Valve Browsing number： |
| |
According Kero Throttle Body informed car throttle action : control of air entering through the throttle position sensor can automatically control the oil . In other words, the throttle control means .
Category : one is by cable to control the electronic throttle that cyborg half , one is given through the sensor signal that is fully electronic throttle , through the computer to calculate the intake air throttle opening angle and with the angle sensor .
[ Harm ] throttle get clean
An irregularly cleaning, opening of the throttle valve causes the generation of an error
Second, the air causes the impurities into the engine combustion chamber.
The result of these two engine abnormalities, mainly idle instability ; sudden momentary stall at high speeds ( close the throttle suddenly feeling ) ; power down ; severe cases can cause difficulty in starting and increases fuel consumption.
Step One: Prepare tools.
On the 10th a small wrench ( removable battery terminal ) , a large Phillips screwdriver ( removable intake elbow ) , the T30 wrench to spend a ( removable throttle ) , carburetor cleaner bottle.
Inside the flower head T30
Step two : Remove the throttle intake elbow
Removing the throttle intake elbow
Gently bend out of the intake
The third step: Unplug the wiring harness connector throttle
Unplug the wiring harness connector throttle
Step Four : Remove the throttle body
Step Five : Remove the throttle body , carried spray .
Remove the throttle body
Spray cleaner
Do not overlook the details
During pulled by hand in accordance with the direction of the throttle activities to be thoroughly cleaned .
Step Six: Place a clean installation of the throttle as ( tighten 3 bolts , plug harness plugs, install the intake elbow ) :
The clean throttle reset
Step Seven: conduct throttle position sensor initialization
Insert the key into the ignition switch screw M bit , wait about 40 seconds .
Turn the ignition off , wait 20 seconds then start the ignition .
The car, insert the key , turn the ignition switch is screwed into the M position, wait about 40 seconds , if very quiet , then be able to hear the sound of da da 30S when the throttle action around .
Then , turn off the ignition switch, wait 20 seconds then start the ignition .
At this point, the throttle cleaning work is completed .
If done incorrectly , the computer will not be able to accurately control the throttle opening , the engine will " limp ." After this occurs , you must place automatically adjust to the 4S device initialization PROXIA ( Citroen maintenance software , similar to the Peugeot PP2000) to return to normal .
|
| |
|
